Ecomobl Surfboard Operating Steps
Quick Start:
1. Load the battery into the surfboard (picture 1). Next, lock the four screws to secure the battery (picture 2). Place the surfboard in the water.
2. Place the safety bracelet on your wrist and insert the bolt into the hole behind the speed control handle.
3. Start on your belly, move to your knees, and finally stand on the surfboard gradually.
Maintenance:
-
When the surfboard is not used in the water for a long time, turn it over or take out the battery and place in a shady area
-
After use in the water, DO NOT idle for more than 30 seconds to avoid damage to motor due to insufficient cooling.
-
When the battery is discharged, loosen the four screws and lift the battery out of the board. Open the protection cover of the punching hole and fully charge it
-
When the surfboard is not used for a while, charge the battery at least once every two months to maintain capacity.
-
After use for three months or use in sandy water, open the filters. Sitting in clean fresh water, start and stop the motor at the low speed setting for 3 minutes. Replace the filter screen (picture 8)
Caudal Fin Installation:
After use in sea water, flush the power system with plenty of fresh water aimed at the sand cover for at least 2 minutes (picture 7)